Whole House Repipe in Little Elm, TX
Second or third slab leak? Patching again rarely ends it. Call (855) 672-0175 to get a whole-house repipe quote from a licensed Little Elm plumber.
- New supply lines to every fixture
- Most homes done in 2 to 5 days
- Water back on most nights during the job
What is a whole-house repipe?
A whole-house repipe replaces every water supply line in your home with new pipe. In slab homes, the new lines almost always run through the attic and walls instead of under the concrete, so future leaks never reach the slab again.
A repipe covers the hot and cold lines from the main shutoff to every sink, tub, shower, toilet, washer, ice maker and water heater. Drains are not usually part of it. Once done, the old pipes under the slab are capped and abandoned.
Signs it's time to repipe
Repipe when you have had two or more slab leaks, see pinhole leaks in exposed copper, notice blue-green stains at fittings, get rusty or metallic-tasting water, or find low pressure across the home. These point to a system wearing out, not one bad spot.
- Second slab leakThe first was not bad luck.
- Pinholes in copperThinning walls throughout the system.
- Green or white crustCorrosion or scale at joints.
- Discolored waterRust or sediment from old pipe.
- Weak pressure everywhereScale narrowing the pipes.
- Selling soonA repipe can ease buyer worries after past leaks.
How a repipe works
A repipe follows a set plan: survey the home, open small access points, run new lines, connect fixtures one area at a time, test everything, then patch drywall. Most single-story homes take two to three days. Larger two-story homes can take four or five.
- Survey and quoteThe plumber maps every fixture and gives a written price, including drywall patching.
- Protect and openFloors and furniture covered. Small cuts at fixture locations.
- Run new linesPEX or copper from the main through the attic and walls.
- Connect, test, patchEach fixture tied in, the system pressure tested and inspected, then drywall closed.
Get a repipe quote
Compare it with what another round of slab repairs would cost.
Whole-house repipe cost in Little Elm
A whole-house repipe in Little Elm usually costs $5,000 to $12,000. A two-bath single-story home with PEX sits near the low end. A large two-story home with three or more baths, or copper instead of PEX, sits near the top.
| Home size | PEX | Copper |
|---|---|---|
| 1–2 baths, single story | $5,000–$7,500 | $8,000–$11,000 |
| 3 baths, single story | $6,500–$9,000 | $10,000–$14,000 |
| 3–4 baths, two story | $8,000–$12,000 | $12,000–$18,000 |
Estimates for North Texas homes. Your plumber's written quote is the real price.
PEX repipe vs. copper repipe
Most Little Elm repipes use PEX. A PEX repipe costs about 30 to 40 percent less than copper, installs faster with fewer joints, and resists hard-water scale. Copper costs more but has a long track record. Both pass code; the choice comes down to budget and preference.
| PEX repipe | Copper repipe | |
|---|---|---|
| Typical cost | $5,000–$12,000 | $8,000–$18,000 |
| Install time | 2–4 days | 3–5 days |
| Hard water | Resists scale | Can scale and pinhole |
| Freeze tolerance | Better | Can split |
| Sunlight | Must be shielded | Not affected |
Repipe or keep fixing leaks?
If you have had one leak, fix it. If you have had two, compare the price of a repipe with a second round of detection, access and flooring. Many homeowners find a repipe costs about the same as two or three spot repairs, and it ends the problem.
Keep repairing
One leak, pipes in good shape elsewhere, plans to sell soon.
Repipe
Two or more leaks, visible corrosion, staying in the home for years, flooring you don't want torn up again.
What a good repipe quote includes
A complete repipe quote lists the pipe material, every fixture connected, new shutoff valves, attic insulation, drywall patching, the permit and inspection, cleanup, and the warranty. Compare quotes line by line. A low price that leaves out patching or the permit often ends up costing more.
Materials and valves
PEX type or copper grade, new stop valves at sinks and toilets, and a new main shutoff if the old one is worn.
Patching and cleanup
Who repairs drywall and texture, and whether painting is included.
Permit and inspection
Repipes need a plumbing permit inside Little Elm town limits; other rules apply in unincorporated areas. The plumber should pull it and schedule the inspection.
Schedule and water access
How many days, and whether water will be back on each night.
Not ready for a full repipe? A single-line bypass may be enough after a first leak.
Whole-house repiping near Little Elm
Repipes are most common in Little Elm homes from the late 1990s and 2000s with copper under the slab, and in older homes across nearby cities.
Whole-house repiping FAQ
How long does a whole-house repipe take?
Most single-story Little Elm homes take two to three days. Large two-story homes can take four to five days. Water is usually turned back on each evening.
Can I stay home during a repipe?
Yes. Most families stay in the home. Expect water off during working hours and some noise and dust in rooms being worked on.
Is PEX good enough for a whole-house repipe?
Yes. PEX is approved by plumbing codes, resists hard-water scale and freezing better than copper, and costs less to install. It must be kept out of direct sunlight.
Does a repipe include drains?
Usually not. A repipe replaces water supply lines. Drain or sewer problems under the slab are a separate repair.
Will a repipe raise my home's value?
It mainly protects value. Buyers and inspectors treat past slab leaks as a red flag, and a documented repipe answers that concern.
Done patching leaks?
Get a whole-house repipe estimate. One call connects you with a licensed plumber who serves your area.